In the following section, you will be programming the Bumper Switch on the robot. The following steps tell you where to attach the Bumper Switch sensor and what materials are needed.
Rear bumper switch
Materials Needed
Bumper SwitchScrew (2)
0.375 OD x 0.500" Nylon SpacerHex Nut (2)
Attach to Rear of Clawbot
Use the screws and hex nuts to attach the Bumper Switch sensor in the center of the back of the robot.
Optional: Use the nylon spacer to create extra room between the red button and the sensor.
Plug the 3-pronged end of the wire into Port A of the Robot Brain. Push the wires in all the way with the white wire on top.
